What is aqua blasting? Aqua blasting, also known as vapour blasting or wet blasting is the non-aggressive removal of surface dirt and grime from metal components . The key to aqua blasting is that the finish is produced through the flow of water borne abrasive. A finer finish is achieved due to the

If your Brake Calipers look really bad. They're rusty or covered in brake dust. They seem to work fine, but just look bad. We suggested that you have them sandblasted and paint them, which sounds a lot better than paying multihundreds for new Bembros or whatever they're called. I'm going to need to

A closed loop wet blast cabinet only requires a compressed air supply and a power source to operate. Once you add abrasive and water to the cabinet, and add water to the external tank, you recycle the water-abrasive slurry mix until you want to change it out.

As a quick-wear part of sandblasting machine, blasting nozzles need to be replaced regularly, that is because the wearing of nozzle mouth causes low processing accuracy.Based on texture materials, the sandblasting nozzles can be classified into ceramic nozzle, tungsten steel nozzle, silicon carbide

As we know sandblasting machine has at least a piece of blasting gun which powered by compressed air, thus for each blast gun the air consumption is 1.0CBM/Min. Sandblasting equipment manufacturered by Kafan includes dry blaster

1. Sandblasting is powered by compressed air with abrasives (carborundum, corundum, etc.) grinding on the surface of the workpiece, while shot blasting is powered by electrically driven high speed impellers and blasting steel shot impacting on the surface.

Generally the pressure range of a sandblaster is 2-8 bar. Why maximum value is 8 bar? it is because the original design is 8 bar, that is, sandblasting process does not need too high air pressure, or the hose inside the equipment will burst. So we should control the inlet pressure at 8 bar maxium, n

Sandblasting is pretreatment process of surface coating, the blasting machine effectively removes rust, oxides, burrs or other contaminants from the workparts surfaces, creates smooth and clean surface, increase the adhesion for better powder coating.

The glass sandblasting machine is specially designed for etching on the glass, With one-step molding, It is the initial and optimal choice of glass etching. The etching results by glass sandblasting machine often presents to be uniform and perfect while it is much environment-friendly than tradition

1, Must wear protective clothes before sandblasting work, not allowed to be in bare, operators not less than two people.2, Gas storage tank, pressure gauge, safety valve must to be regularly checked. The gas storage tank emits dust once two weeks, the filter in the abrasive funnel must be checked on